I&C Engineer

The I&C Engineer will be responsible for overseeing and managing various aspects of instrumentation and control systems in power projects. The successful candidate will play a crucial role in the planning, design, installation, and maintenance of I&C systems, ensuring compliance with industry standards, regulations, and project specifications.

Your Job Functions (Duties & Responsibilities)

Supervision & Oversight:

Monitor and supervise all I&C works executed by the EPC contractor and their subcontractors.

Ensure adherence to project specifications, national and international standards (e.g., IEC, ISA), and HSE regulations.

Review and approve I&C installation and commissioning procedures.

Ensure alignment of I&C activities with project objectives and timelines.

Technical Review & Assurance:

Participate in design reviews, HAZOPs, control philosophy reviews, and FATs (Factory Acceptance Tests).

Review and comment on I&C drawings, instrument datasheets, loop diagrams, I/O lists, and control logic documents.

Interface Management:

Coordinate with other engineering disciplines, especially electrical and mechanical, to resolve interface issues.

Serve as the focal point for I&C-related technical queries and non-conformance issues.

Commissioning Support:

Oversee pre-commissioning and commissioning of I&C systems including loop checks, calibration, and signal verifications.

Verify compliance of DCS/SCADA systems and ensure proper integration with plant systems.

Reporting & Documentation:

Maintain accurate records of site activities, inspections, deviations, and resolutions.

Prepare weekly progress reports highlighting key risks, issues, and achievements.

Compliance & Quality:

Ensure traceability and compliance with QA/QC standards.

Support audits, inspections, and punch listing for I&C scope.

Accept individual responsibility for their own safe behavior as well as share responsibility with their fellow workers and line supervision to look out for their own as well as their co-workers safety

Comply with and constructively participate in the Project HSSE activities

Work in a safe manner at all times and contribute to the implementation of the ‘Incident and Injury Free’ philosophy

Stop any unsafe act/behavior observed and report it to their line supervisor/manager

Take reasonable care for the safety of themselves and other personnel who are at the workplace, and who may be affected by any acts or omissions on their part

Co-operate with their employer in ensuring that their workplace is as safe and healthy as is reasonably practical

Report any hazard or potential hazard in the workplace or any incident, personal injury, accident or near miss that may have occurred during the course of work to the HSSE staff immediately

Correctly use, store and maintain PPE issued to them for protection against workplace hazards

Follow all verbal or written safe work procedures, practices and directions

Observe all warning signs and notices

Attend toolbox meetings and all other HSSE meetings as required

Attend all scheduled relevant HSSE trainings

Comply with work instructions and permit requirements